Access Point Ethernet Cable

Connect the ap to the existing network.

Access point ethernet cable.

The cable should be inserted into a lan port on the router and into the main ethernet port on the access point. Plug one end of the cable into one of the lan ports of your wireless access point and the other end to the ethernet port on your computer. With the new r7000 as access point i used the wan port as suggested in the manual. If a network cable is too long or of poor quality it won t carry a good network signal.

I have tested the transfer times. I tested many times and here are the average speeds. An ethernet cable is a common type of network cable used with wired networks. An access point is a device that creates a wireless local area network or wlan usually in an office or large building.

Your secondary access point should now be online and accessible to the wi fi devices nearby. Several mainstream vendors of consumer wi fi products manufacture access points which allow businesses to supply wireless connectivity anywhere they can run an ethernet cable from the access point to a wired router. 2 connect your wireless access point to your computer using an ethernet network cable. An access point connects to a wired router switch or hub via an ethernet cable and projects a wi fi signal to a designated area.

3 turn on your dsl or cable modem and wait about two minutes. The main router is also r7000. Use an ethernet cable to connect the access point to the router. This introduces the access point to the router s created local area network.

Copying a 2065 mb file from a desktop wired to the router wired connection to the access point and then wired connection to a laptop with ssd disk. Run an ethernet cable from the wall jack to one of the lan ports on the secondary router not the wan port. Other computers on the network should now be able to access the ap configuration interface by opening a browser and typing the ap ip address in the browser address bar. Disconnect the ethernet cable that connects the ap to the computer and connect the ap to your existing network.

Ethernet cables connect devices such as pcs routers and switches within a local area network. There are several cables that the user will need to connect. Plug in the power cord to boot it up.