Above Ground Pool Liner Installation Tips

Meaning nobody is going swimming in an ice bath.

Above ground pool liner installation tips.

Helpful above ground pool installation tips and tricks written by our pool experts at the pool factory. Installation of an above ground pool liner. This is a big deal and care must be taken. As the pool fills work out all the wrinkles and smooth the liner to the wall.

Leaks are also a major contributor to pool corrosion or rust. Through the wall s return s lights etc. This is the kind of liner you ll end up with with you re looking to install an above ground pool with a deep end. Definitely do not install the liner if it is colder than 70 degrees.

You may use a sump pump your filtration system or siphon hose step 2 remove all hung ladders from liner area and any other equipment that may obstruct liner area step 3 remove all face plates and gaskets from inside pool area i e. Tips to install the pool liner. Start filling the pool with only a few inches of water. Overlap liner installation using coping strips if you end up with excess liner material continue around the pool pulling excess liner evenly and distribute over the pool wall until the excess is gone.

Learn by our step by step tutorials. Start by making sure all the water is drained out of your swimming pool. Wait for a nice sunny day. It likely goes without saying but unwanted moisture is the primary cause of premature corrosion of the pool wall and frame.

Leaks can ruin a pool. Above ground pool liner installation tips. Just as the name suggests the liner literally overlaps drapes over the side of your pool wall and is then secured by the pool s top rails. As you re pumping out the water make sure you re pumping it as far away as possible to avoid making a mess underneath your pool.

Overlap liners are the most economical choice in above ground liner. Step 1 drain all water from pool. You must install the liner on a warm sunny day and check to ensure the evening temperature doesn t dip too low. Lay the liner in the sun for a few hours before you start so it is easier to lay out.